Size

• Length: 6.1 in. (15.5 cm)
• Width: 1.7 in. (4.4 cm)
• Depth: 3.4 in. (8.7 cm)
• Insertable Length: 3.9 in. (~10 cm)
• Insertable Diameter: 1 in. (2.5 cm)
• Plug Weight: 5.1 oz. (145 g)
• Remote Weight: 0.9 oz. (26 g)

Material

• Silicone & ABS Plastic

Charging Travel Lock On/Off:

Your Massager will be shipped with travel lock active.

To Lock - Press and hold the middle (Warming) and top (Head Vibration) buttons at the same time for 3 seconds. The motor will buzz ONCE and the LED will blink ONCE at the same time. The massager is now locked.

To Unlock - Press and hold the middle (Warming) and top (Head Vibration) buttons at the same time for 3 seconds. The motor will buzz TWICE and the LED will blink TWICE at the same time. The massager is now unlocked.

Charging

• Charge Time: 120 mins
• Run Time: 45 mins
• Vibrator While charging - All 3 LED’s will blink
• Vibrator Fully Charged - All 3 LED’s will stay solid

Remote

• Charge Time: 120 mins
• Run Time: 10 hours

Use

Standby Mode
To place the massager into standby mode, press and hold the power button on the massager for 3 seconds. A dim LED will turn on and stay solid—you may now use the buttons on either the massager or the remote. To turn off standby mode, press and hold the power button on the massager for 3 seconds.

P-Spot Vibration
Once in standby mode - Press the left button on the massager or the top button on the remote for to turn on the head motor. The button will light up, and the motor will begin vibrating in the lowest setting. Each press will cycle through the ten modes of vibration and the LED will change in sync with each mode. Press and hold the button on the massager or remote for three seconds to turn off.

Warming
Once in standby mode - Press the middle button on the massager or remote to activate warming mode. The button will light up and stay solid while warming mode is active. The massager should warm to just above body temperature in a few minutes. Press and hold the button for 3 seconds to turn off. Please note this will turn off all functionality.

Perineum Vibration
Once in standby mode - Press the right button on the massager or the bottom button on the remote for to turn on the base motor. The button will light up, and the motor will begin vibrating in the lowest setting. Each press will cycle through the ten modes of vibration and the LED will change in sync with each mode. Press and hold the button on the massager or remote for three seconds to turn off.

Power Off
To stop all motor functions, press and hold the power button on the massager or remote for 3 seconds. Please note, standby mode can only be turned off via the power button on the massager. Caution - To prevent the battery from draining, always turn off standby mode after use (by pressing and holding the power button on the massager for 3 seconds. The LED will be off in standby mode).

Cleaning

Spray Jimmyjane Antibacterial Cleaner on the massager before use. Wipe with a clean, dry cloth and let it air dry. Repeat after use and store in a cool, dry place.

Warnings

This massager is for novelty purposes only, is not intended for therapeutic purposes and is recommended for external use only. Prolonged use for more than 30 minutes or frequent use of more than twice daily is not advised or recommended. This massager is intended for adult use only. Use water-based lubricants only.