Specifications & More Details - Pure UV Sanitizing Mood Light Plus Love Pod Tre

  • Rechargeable
  • ABS Plastic

Size (Pure Mood Light)

  • Length: 6 in. (15.2 cm)
  • Diameter:  5 in. (12.6 cm)

Size (Tre)

  • Length: 3.1 in. (7.9 cm)
  • Diameter: 2.4 in. (6 cm)
  • Ear Length: 1.1 in. (2.8 cm)
  • Ear Diameter: 0.6 in. (1.5 cm)

    Charging

    • The Love Pod Tre Charges in 150 Minutes

    Use

    Pure Sanitizing Mood Light

    Plug the USB cable into a powered USB port and then plug into the back of the base. Insert the acrylic plate (clover shaped plate for the FORM 2 or the oblong shaped plate for the Love Pods) into the base. Place the massager onto the charging contacts. When the massager is connected properly the LED on the massager will light up indicating that the massager is charging. 

    Sanitizing/Charging

    Place the mood light lid onto the base. The LED on the lid will turn on and be bright pink indicating that the Pure is sanitizing the massager. The sanitizing cycle will take approximately 10 minutes, and once done sanitizing the LED will turn bright blue to indicate that the massager is charging but no longer sanitizing. The LED can be turned off by pressing the button on the back of the until until the light turns off, but once the sanitizing cycle is complete, the LED will turn back on in bright blue. Press the button on the back again to turn off the LED.

    The Pure LED has 4 light levels (low, medium, bright, and off) and will start in the brightest setting. Press the button on the back of the unit to cycle through the brightness settings. Once the LED has been turned off, the next press of the button will turn on the LED in purple at the low setting. From this point until the lid is removed the LED color will stay purple when on, and the light level can be adjusted as desired.

    Tre

    Press the + button to start vibrations. Once on, press the mode button to cycle through the 4 modes of vibration. Press the + and - buttons to control the 5 power levels for each mode. To turn off vibrations press the - button until the vibrations stop. 

    Travel Lock

    The massager will ship with the travel lock activated. 

    To Lock: Press and hold the mode and + buttons for 3 seconds. When any button is pressed the massager will not activate and the LED will continuously flash indicating the massager is locked. 

    To Unlock: Press and hold the mode and + buttons for 3 seconds. The massager should work as normal. 

    Cleaning

    The Pure UV Sanitizing Mood light uses UV light to sanitize the surface of your massager, but we suggest you continue to clean your massager by hand before and after each use in addition to sanitizing. To clean, spray Jimmyjane Antibacterial Cleaner on the massager before use. Wipe with a clean, dry cloth and let it air dry. Repeat after use and store in a cool, dry place.

    Warnings

    This massager is for novelty purposes only, is not intended for therapeutic purposes and is recommended for external use only. Prolonged use for more than 30 minutes or frequent use of more than twice daily is not advised or recommended. This massager is intended for adult use only. Use water-based lubricants only.